top of page
How To Install
For mounting on Masonry-Stucco, Brick and Vinyl Siding.
For Wood - Use same instruction but skip the anchor installation
(Do not attempt to mount your plaque using just adhesive)
These plaques are pre-drilled with two 5/32" holes. (For inlay mounting into stucco or into brick, ask for your plaque without the holes)
Besides your plaque, you will need; a level, a pencil, a 1/4" masonry bit and drill, two 1 1/2" to 2" #8 stainless steel screws, #8 plastic anchors, a screwdriver and a hammer.
With the level on top of the plaque, level the plaque so that the 2 holes meet with the cement joints (if installing on brick) and not the brick (If possible, try not to drill into brick).
With the level on top of the plaque, insert the pencil into the two holes and make your mark.
You should have two very visible pencil marks.
Using your 1/4" masonry drill bit, drill your marks deep and wide enough to fully accept the length and width of your anchers.
Insert your plastic anchors into the holes (They should fit snug).
Heading 3
Use a hammer to gently give the anchors their final push in.
To make the final installation easier, Fully screw, then unscrew the screws to set the anchors. This will allow for a smoother installation of the plaque.
Remove the screws and get ready to install your plaque.
Using a screwdriver, Line up the holes and install both screws half way. Continue tightening, alternating screws, until they feel lightly snug. Do not over tighten the screws, Your next turn might break the plaque.
Step back and enjoy
bottom of page